NEED HELP ASAP!!!!!!!!!!!!!!!!!!!!!!Asking all 6.0L pros

[20007.3L]

2005 F5506.0L
replace camshaft sensor and crankshaft sensor and now wont start. Anyone please help me, need this trUck for the AM
any ideas????????/

 

[POWER-STRUCK]

pull up pids and see if ficm gets sync

 

[co04cobra]

Need to get it hooked to a scanner. Check ficm voltage, sync, icp, ipr. Why were the sensors replaced?

 

[20007.3L]

Maintence, it was hooked to a scanner and is reading no codes at all

 

[20007.3L]

This truck was just running yesterday

 

[Atsah]

What was wrong to begin with? no start?

 

[POWER-STRUCK]

check for debris between cam sensor and the block

 

[20007.3L]

cylinder 7&8 misfunction, not firing
crankshaft, camshaft code and glowplug code

 

[dieseljosh07]

Cam sensor wiring harness connector. Check FICM sync with a scanner. I've had issues before with that connector after it's been unplugged, the pins don't make clean contact with the pins in the sensor.

 

[20007.3L]

check for debris between cam sensor and the block

there were alot of codes listed above

 

[POWER-STRUCK]

did you mess with the ficm? check to see if ficm connectors are fully seated

 

[Nic]

ficm

 

[20007.3L]

Cam sensor wiring harness connector. Check FICM sync with a scanner. I've had issues before with that connector after it's been unplugged, the pins don't make clean contact with the pins in the sensor.

did you rerplce or clean the plug?

 

[Atsah]

Is the FICM funtioning correctly? Connectors all good?

 

[20007.3L]

did you mess with the ficm? check to see if ficm connectors are fully seated

i was no where near the FICM

 

[20007.3L]

only replace the 2 sensors

 

[20007.3L]

diconnected the ground on the block, now wont start

 

[POWER-STRUCK]

check for rust scale on block under the cam sensor, may look shiny but chip it off

 

[20007.3L]

check for rust scale on block under the cam sensor, may look shiny but chip it off

What does that do ground

 

[POWER-STRUCK]

causes too large of sensor gap to tone ring