Recent content by Betarocker

Shart, never saw that before I posted. Can't imagine how much that sucks.

Get some OUO ALAs to correct the axle/caster.

Contact AMP and purchase the wiring harness and controller for a kit #75134-01A

Bought a bunch of tools and parts to rebuild shocks. There is no Fox service location in Canada so I did some quick math and figured in a few cycles I'll break even. Factoring the cost per shock re/re plus parts, and shipping both ways.

0" to 3.5" is a noticable change, 3.5" to 4" is negligible. As this is your truck, how your lift is attained is your decision. If I was looking at lift at that height I'd go with a spring lift to gain travel, and use adjustable radius arms to get the knuckle geometry set. Readylift is not a...

Installed a set of Ride Rite airbags. Wasn't as easy as the instructions made out, but that was mostly due to having OUO Traction Blocks which required drilling the jounce pad. The Jounce bumpers were somewhat rusty, and the lock nut was stubborn. Things got a bit easier after dropping the...

He's doing well. He did a trip through the Pacific Northwest before his move to San Hose-A from PDX. He'd never been here to Whistler in the summer; 10 or so times in the winter though.

Have a friend visiting who dabbles in photography, shooting for truck magazines and online stuff. Went out with the camera and took a few shots.

2.0 Performance Series IFP 4WD Front 4-5" 985-24-061 $139.95 2.0 Performance Series IFP 4WD Rear 4-6" 980-24-665 $139.95 https://www.ridefox.com/subhome.php?m=truck&p=&make=Ford&model=F250&year=2016-2005&position=ALL

Haven't taken a picture from this angle before.

Just measured to confirm. M12x75 1.75 pitch https://www.homedepot.com/p/Crown-Bolt-M12-1-75-x-75-mm-Zinc-Class-8-8-Metric-Hex-Bolt-04328/203539430?MERCH=REC-_-PIPHorizontal2_rr-_-203539392-_-203539430-_-N

12mm nut and bolt is what it was. Grade 8.8 . 1/2" is just a bit too large.

How are the rest of your steering components? Ball joints, tierod ends, draglink ends, pitman arm nut, steering box, wheel hubs, etc? Alignment? Remove the dampers and drive with them off to see if it does it too. Sometimes you get used to something and don't notcie it until you change something.