Recent content by F350eightyAM

Any input appreciated

Replaced HPFP thinking that was the problem. No pressure is building up in fuel system. I have pulled the valve covers. Then pulled each glow plug one at a time KOEO then hearing the fuel drain out into the drain pan. I was doing this thinking the cylinder would fill with fuel and come out the...

Replaced HPFP thinking that was the problem. No pressure is building up in fuel system. I have pulled the valve covers. Then pulled each glow plug one at a time KOEO then hearing the fuel drain out into the drain pan. I was doing this thinking the cylinder would fill with fuel and come out the...

UPDATE... Pulled the passenger side valve cover diesel is just leaking in to the engine via the high pressure pump. When I turn the key diesel is pouring out, Can't see where the leak is coming one of the back two injectors. Going to work on it more tomorrow

Update Replaced the HPFP and lift pump. Then bled 1/4 of tank of fuel getting the air bubbles out. Still no pressure building up. Checked the oil and there's fuel in the oil. So there is a failure somewhere in the fuel rail. When truck first failed to start I was starting and immediately it...

Greetings Everyone, I want to start by saying any help advice is much appreciated. My truck sat for three days before i tried starting it. When I did I wasn't thinking and just started cranking with out letting the glow plugs warm. As soon as I did it threw the P2291 code immediately. I changed...

No the there is not diesel in the oil. Changed out the hfcm same results

My truck is slow to start. The fuel rail pressure is low at first while cranking then the pressure builds up in 3-4 second into the crank then starts. Any ideas of what it could be. ??? I've had electrical issues with the alternator over charging( 16V )replaced that today.

The TCM was bad crank right up with a new TCM

Turns out TCM here is the pintest for it Ordering a TCM hopefully all will work out

I have a sct tune. I have tried to bypass the the start relay it will crank but not start. checked the power to the tcm it is getting power. Haven't checked the grounds though. Going to do that tomorrow. Going to the junkyard tomorrow to get a TCM there only 35$ The weird part is that I tried to...

I ran diagnostic and I received the code U0101 TCM not communicating. If the TCM malfunctions will that cause the truck not to start??Or is it something else ?? Going to check the power to the TCM also the shift light is not working

I just bought my tuner. What is the best canned tune? Should I adjust trans shift points ? Newbie at tuning. What I want is a smooth ride with power when I want it daily driver. Not looking to go crazy. I have dog ****** ear ****** s&b intake Running 33s