Search results
-
AC system replaced but still not cooling efficiently
It’s been a few years back but I worked on an 05 excursion that the rear ac wasn’t cooling well. Replaced expansion valve and still no change. Come to find out there was another orfice tube under the truck at the rear, basically right above the tailpipe and right before the ac line goes into the... -
6.4 Rebuild - Valvetrain Movement ('Lift') - Very Little
I’ve pulled apart many early build 6.4 engines that have the same length pushrod as 6.0. Still think the lifters need oil to bring up the slack. Why would RCD mass produce a pushrod that is too short? Those guys know what they’re doing. Sent from my iPhone using Tapatalk -
6.4 Rebuild - Valvetrain Movement ('Lift') - Very Little
Lifters need oil as sootie said. Sent from my iPhone using Tapatalk -
6.0 bullet pruffing
Alliant power/pure power for stock size Sent from my iPhone using Tapatalk- webb06
- Post #4
- Forum: 6.0 Aftermarket
-
Dual Fuelers
The second pic is more of the stock routing on all of the other pulleys. I’d go with that Sent from my iPhone using Tapatalk- webb06
- Post #11
- Forum: 6.4 Aftermarket
-
7.3 valve wear, have a look
That was my best guess as well. Still has factory air box though. Probably ran many miles with bad filter or open intake. Sent from my iPhone using Tapatalk -
7.3 valve wear, have a look
97 OBS 7.3 power stroke 251k miles Engine had an uneven crank and low compression on cylinder 8. Popping through intake. Verified that it was the intake valve by pressurizing that cylinder with both valves closed. Pulled the head to find the face of all of the intake valves extremely worn... -
Cab off repair and lift installed on my 6.4
Sounds like an injector Sent from my iPhone using Tapatalk- webb06
- Post #65
- Forum: 6.4 Aftermarket
-
Cab off repair and lift installed on my 6.4
Assuming injector. We had them all tested and several didn’t pass. Sent from my iPhone using Tapatalk- webb06
- Post #58
- Forum: 6.4 Aftermarket
-
Cab off repair and lift installed on my 6.4
Agreed. First time I’ve seen one cracked. Sent from my iPhone using Tapatalk- webb06
- Post #56
- Forum: 6.4 Aftermarket
-
Cab off repair and lift installed on my 6.4
What makes you think the coating comes off? I just had a 6.4 apart that had coated pistons installed 20k miles ago and they all looked fine, except for the cracked one. Sent from my iPhone using Tapatalk- webb06
- Post #54
- Forum: 6.4 Aftermarket
-
Motor Mounts
If you pull the plastic intake off the top of the engine there might be room to get a picker and raise it some. You can easily pull the fan shroud, fan, and stator without pulling the rad, although it probably won’t get you much more access unless you’re standing on your head. Sent from my... -
PLEASE HELP!! 2009 Powerstroke 6.4L CODES P1000 & B2900
P1000 code is nothing. Means that the codes have been cleared but a drive cycle hasn’t been done. Used only for vehicle inspection, so they know if you’ve cleared the code in the parking lot just to get the engine light to go off. Sent from my iPhone using Tapatalk -
P04DB code
Since when will a minimax work on 2015? Sent from my iPhone using Tapatalk- webb06
- Post #2
- Forum: 6.7 Aftermarket
-
IPR 85% No Start, No codes....out of ideas
Pics don’t load for me. What’s icp reading while cranking? Sent from my iPhone using Tapatalk -
EGR Upgrade Question
Without answering every question. Egr removal won’t change the exhaust sound of the truck at all If you’re wanting more drone sound then non vgt is for you. If you’re wanting the whistle tone then an upgraded vgt turbo is for you. Sent from my iPhone using Tapatalk- webb06
- Post #2
- Forum: 2017+ 6.7 Aluminum Super Duty
-
Constant regen
Wish I woulda thought of swapping a pcm...hahahaha Sent from my iPhone using Tapatalk -
Died at idle - No crank
If it won’t crank using the starter wire then either batteries are dead or starter is dead. It’s a direct wire to the starter solenoid. Sent from my iPhone using Tapatalk -
Truck will not shift from Park (electrical)
First guess would be the brake switch on the brake pedal Sent from my iPhone using Tapatalk -
2015 Cooled Seat, Back Not Working?
My 2012 only cools out the bottom cushion I believe. Sent from my iPhone using Tapatalk
