Reply to thread

Message: [QUOTE="FX4 F2-Fifty, post: 338161, member: 245"] I dont have anyway to measure it right before the regulator. But as it was said the gauge port is on the inlet. before it hits the diaphragm so it will be the same? :whs: this is what i would like to accomplish. verified with two gauges that i only have 55psi at the regulator. 5/8 from tank to pump. 1/2 from pump to fuel block. Not sure what size the AN lines are going to the heads. and out the back of the heads it is stock banjos and hardlines up over the rear of the motor and then the same size AN from the hardlines to the regulator. Its an Elite fuel system that was designed to use the stock fuel bowl originally. Using the stock feed as the return line i believe. and if the return line was the restriction then the pressure at the regulator would be 100psi [/QUOTE]

Verification

Random media

303-black-Hoodie

The Truck

rear_axle

Always changing to make it a home on the road.

mpd_2

1291077782438

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- A moment ago
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Today at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Today at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Yesterday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

Total: 1,218 (members: 4, guests: 1,214)

Top