2008 F250... 37s on a leveling kit?

taterthedog · Oct 4, 2012

So I am under the impression that I can run 37x12.50s on stock rims with just a leveling kit. Is this right? I have some aluminum 18s off my wifes '05 that I was thinking of painting black and putting some 37s on. Then a leveling kit in the front and a F350 block in the back is what I'm hoping will let them fit. Truck is an 08 F250 cclb. Am I out to lunch?

Aaron S · Oct 5, 2012

The tire is probably going to contact something on the front of the truck. Cant do anything about the fact that it will hit the radius arm. I bet you can get away with pulling the rear of the fender liner back and maybe have to position the front bumper forewards some.

Do some searching on either PSN most likley or here. I remember a guy did what your thinking about on either an 06 or 08 truck.

NCPowerStroke · Oct 6, 2012

if you go with 35s you will be ok.

Powerstroke214 · Oct 6, 2012

Some people have run 35s on stock height trucks(not sure of offset tho), so I would think you could run 37s with a level and some trimming, but I don't know for sure.

Sent from the Bayou

skew12 · Oct 6, 2012

I believe Jesse's (MBRP) white truck originally had that setup with some 20x9 BMF's. not 100% on that though.

B.Warning · Oct 8, 2012

You'll be fine has long as you stay with stock wheels, or a wheel without crazy offset.

taterthedog · Oct 8, 2012

That's pretty much what I was thinking. Planning on stock 05 aluminum wheels.

Jeff@Spartan · Oct 8, 2012

I think Nitto makes a Trail Grappler that is a 37/12.50/20. It should fit with factory 20's and leveling kit. You may have to zip tie the fender liner back, but it should fit.