Reply to thread

Message: [QUOTE="bad moose, post: 749876, member: 359"] I have a brandy new service truck. F550 with a maintainer bed and crane I scale at 18860 lbs and just put on the final piece to the truck. A 450 lbs Trailblazer welder. Well all was fine and dandy before the welder, the truck now leans 2 to 3 inches on the rear towards the drivers side. Go Figure. The welder is mounted on top of the toolboxes at the rear, air compressor at the front on the drivers. The crane on the pass side. Bed mount is not an option but would work the best just not enough room. and I have to watch my weight, can't go over 19500 lbs, I'm at right around 19250lbs right now. Was thinking air helper springs but know nothing about them pro's or con's. Also if any vendors could help depending on options and thoughts. [/QUOTE]

Verification

Random media

IMG_20130401_231902_550

raptor6

06 sick-o

2016 F250!

sw_vs_jd1

front_14

IMG_20150418_210029882_HDR

Radiator

Center Console

20140904_154807

led light bars

2011-10-01_11-30-51_381

Latest posts

Truck slipping into 4th
- Latest: blackbeauty7.3
- Yesterday at 11:04 AM
6.7 Tech
Performance shops
- Latest: DEEZUZ
- Yesterday at 8:42 AM
7.3 Performance
Indiana
- Latest: glog
- Monday at 10:20 AM
6.4 Tech
Will a 1996 F6TZ-9A451-F engine wiring harness work on a 1997 f250 HD ?
- Latest: NotThatGuy
- Monday at 12:45 AM
94-97 Aftermarket
I
A few turbo questions and a rant
- Latest: INFRNL
- Sunday at 4:05 PM
7.3 Aftermarket

Members online

Total: 657 (members: 2, guests: 655)

Top