Reply to thread

Message: [QUOTE="tomlin, post: 1555175, member: 13915"] Moog is about the best option. I would avoid Dynatracs for one reason. Almost all of the aftermarket ball joints have a knurled side where it fits into the a-arm in your case and the knuckle in a 4x4. Our truck are old enough that these likely have been installed at some point, if they have, you cannot use Dynatracs. They don't tell you this at all in the instructions or sales footnote. The Dynatracs will fall into the hole without press fit after knurled joints have been installed. I made a $600 mistake on my 2000 F-350 4x4. Waited too long after getting the ball joints to install them and could not return them. I have them sitting a on a shelf collecting dust. So any of you guys looking to splurge on Dynatrac ball joints beware. The only fix is new knuckles for us Ford guys. Dodge guys get a knurled option from Dynatrac as the ball joint presses into the axle housing. [/QUOTE]

Verification

Random media

IMAG0723

My OBS E-Fuel system

20110524164817

chrome

rear seat

Door harness plugs

exploded

IMG_20130124_182557

Truck pics.

My 2011 F250 Lariat

VVASSUP Juanito's F250 05 6.0 Harley Davidson TOYO RIZE RBP SCT MBRP S&

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 907 (members: 0, guests: 907)

Top