96 F-350 Dana 60 & 10.25 Axles Complete Swap Setup

[mjonesjr]

I have a '96 Dana 60 with the leaf springs, steering, track bar, track bar bracket, and u-bolt plate. It has 3.55 gears. It includes everything except for the lockouts.

Price: $1,000

Location: Salem, IN 47167

Shipping: Buyer is responsible for all shipping


I also have a rear Sterling 10.25 axle with 3.55 gears. It is complete drum to drum.

Price: $250

Location: Salem, IN 47167

Shipping: Buyer is responsible for all shipping



I would do a package deal on both axles for $1,100.

 

[mjonesjr]

Both axles for $1,000.

Here is a couple pictures. They are crappy, but it was dark.

 

[mjonesjr]

Daily bump!

 

[Lamont_24]

Where are you located?

 

[kadeninabnitt]

I barely got 600 for my 60 I sold a few weeks ago

 

[mjonesjr]

Where are you located?

Salem, IN

I barely got 600 for my 60 I sold a few weeks ago

Yours was just the axle though. I've got everything for a F-250 solid axle conversion and a rear axle. That makes a difference when the track bar runs $100-$150, the track bar bracket runs $150, and the driver side u-bolt plate runs another $150.

 

[Lamont_24]

****, your about 5 hours away. A little far for me. But thanks

 

[mjonesjr]

****, your about 5 hours away. A little far for me. But thanks

If you are interested I could meet you half way with them. Where are you located?

 

[Lamont_24]

I'm near south bend, your about 5 hours away. But my trucks getting a transmission right now so I wouldn't have a way of hauling them back. If you still have them when my truck gets done then I'll be very interested

 

[mjonesjr]

Just let me know. As its going I'm sure I'll still have them.

 

[Lamont_24]

Alright I'll keep you informed

 

[mjonesjr]

Bump. I'd like to get these off my trailer.

 

[mjonesjr]

TTT.

 

[FORD7.3]

man if you were a little closer id be all over these...

 

[mjonesjr]

Where are you located Bryan?

 

[mjonesjr]

Daily bump.

 

[FrankTheTank]

It says complete with no lockouts..... where are the rotors?? Will the d-50 rotors work? If i recall correcty they will not, but i may be thinking of the spindals

 

[mjonesjr]

The rotors are in my garage. The Dana 50 rotors and calipers will work. The spindles is what is different. The only difference in the spindles is the base where it mounts to the knuckle.

 

[FrankTheTank]

I knew they spindles were different, wasnt sure about the rotors. I will let my buddy know and let u know

 

[mjonesjr]

Sounds good.