Reply to thread

Message: [QUOTE="Mdub707, post: 908403, member: 107"] Either the stud is yielded or it's not... if it's not yielded I see no issue in re-using them. I went ahead and contacted ARP for dimensions of the studs and the tolerances and actually measured my studs after they had been used once (standard ARP's) and they all fell within that tolerance which told me they had not been physically damaged. They've been holding great on this last head gasket job (dealer did first job and they blew almost immediately, likely heads that weren't flat caused that though). I mean, I can see the concern and in the scheme of things the money isn't worth doing the job again, but as long as someone was able to verify the material was still good... what's the harm? [/QUOTE]

Verification

Random media

PB230071

Picture_153

Screenshot_2013-12-03-06-06-22-1

When the truck was new.

543119_3223576528697_812827396_n-2

Dyno_for_Dex_8

Smokyred

30098_1203722752143_1800846961_410279_3523261_n

Kazakhstan

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

Total: 1,266 (members: 2, guests: 1,264)

Top