Reply to thread

Message: [QUOTE="Rideracelivemx7, post: 304221, member: 305"] Hey guys, I just finished mynvalve spring install with 9-10s and the jegs valve Height tool, you ins tall e tool at lowest height for ease of installing keepers. Then you extend it till it's just about snug and turn the dial towards you so you can see and turn it .05 out and that should be pretty dead nuts to Installed spring height. I have 178k on my truck and WITHOUT the valve seal which equates to a .060 shim. My truck was what I thought in spec. All my valves measured to 1.82-1.830. So you subtract the shim which brings you to a valve up to 1.76-1.77. I added a .015 shim which brought my valves to a 1.745-1.755 which mentioned above is where we roughly want to get to our goal of 130-134lbs of seat pressure And the reason I said with out the valve seal is because I found it doesn't exactly fit in this skinny little tool. [/QUOTE]

Verification

Random media

IMAG1140

The Rig

2013-02-12_14-57-31_363

Studded 08KR64

Elite WG

step_11-1

drag_wheels_mounted

Switch

amps

My rig

truck20

Latest posts

A few turbo questions and a rant
- Latest: Tiha
- 17 minutes ago
7.3 Aftermarket
N
Ford 7.3 Passenger Bank Dead
- Latest: NitroJoe
- 52 minutes ago
7.3 Tech
Georgia Roll Call
- Latest: RascalMafia
- Yesterday at 2:52 PM
Southeast US
Stage 2 LPFS for a 6.0 Powerstroke
- Latest: powerlifter405
- Friday at 11:58 PM
Engine and Drivetrain
0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Friday at 2:44 PM
Aftermarket Performance

Members online

Powerstroke Racer

Total: 1,394 (members: 2, guests: 1,392)

Top