Reply to thread

Message: [QUOTE="AKHILF, post: 849802, member: 1572"] I have mine inside the frame water separator to the rear. I'm almost positive the serial number is towards the frame. I bought this ad2 about a year and a half ago I don't know if they changed where the serial number is. I had to change motors on the side of the road at -10 yesterday. My first pump (the one I put back in yesterday) fried fuses left and right. Called them up and they sent me a new one. This new pump (the second pump iv had) was fine pretty much always. Then all of a sudden yesterday it dropped pressure completely. 0 psi truck was still running, if I revved up the motor it would come up to around 8 psi. Check the fuses, they where fine. Took a test light to the harness right before and after the connector for the motor and had power and ground but the motor won't turn on. Put the old motor in and right back to 65 psi. I'll call and get a new motor on the way tomorrow. I'd just like to not have to pull the base off in negative weather to see the serial number if possible. [/QUOTE]

Verification

Random media

IMG_20150121_145944_383

Connectors

2011-10-21_18-42-28_352

IMAG0539

08 center console painted meddium pebble to match my 06

sept_29_10_170

06 door wire harness

DSCF1079

IMG_4966_1_

IMG_20150801_182531279

17_2_1_

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

No members online now.

Total: 996 (members: 0, guests: 996)

Top