Reply to thread

Message: [QUOTE="JrStroker, post: 675061, member: 10822"] It does look likes its mounted a little low, I was looking at that, but its just the way he mounted it so it didn't bother me because I could mount it higher like what you said you did. I like the reg in the engine compartment idea! I honestly don't trust myself to build my own. Haha. Now with the deal with it getting dirty on the outside frame rail. Here is an idea, I wonder if you could make a small aluminum box, or sheet metal box and tig weld it up to mount to the frame. Then mount the fuel pump to the frame inside the box with enough room under the filters to remove them. Then with the seperator drain, you could cut a hole in the bottom below it and put wire mesh over it. Then have you a small door that folds and mounts. Its just an idea, maybe to big, or to complicated or something. Again, just an idea. [/QUOTE]

Verification

Random media

Pfm top

896D5EC6-A103-4684-A4BF-9BC2E3D549C0

DSCN3559

Dg_8002

eleanor_part_two_61_

MBRP DP

6_4Hopper

16994152778_284378979_IM1_06_565x421_A_562x421

Step_101

OBS_before_and_after

DSCF1085

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Today at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

Powerstroke Cowboy

Total: 1,074 (members: 1, guests: 1,073)

Top