Reply to thread

Message: [QUOTE="a_moore, post: 1561305, member: 807"] Today's list of remaining items. Cut shifter hole back, install boot. Cut battery box ac support for hot side. Tighten compressor housing, final. Change adapter plate bolts. Jack up and weld rear mounts to frame. Cut and mitre hot side pipe, easy. Fab cold side pipe. Brake lines master to ABS mod. Weld res for power steering. Have line made for power steering. Shorten rear drive shaft. Lengthen front drive shaft. Heater core lines. Lower radiator line finish adapter. Upper radiator line support used factory. New belts. Pulley bolts for water pump. Patch hole In firewall. Make 1.5" cab mount lift blocks. Install air filter. Turbo drain hose and clamps too short. Wiring harness bullshit for sensors. Check timing, set to 20° Increase fuel at rack. Turn star wheel. Order 4 electric fans. Fab radiator shroud for fans. Wire in fans and controllers. As you can see, it's a lot of stuff. [/QUOTE]

Verification

Random media

IMG_3515_2_

DSCF3330

gate

2011-04-20_14-48-01_917

VVASSUP Juanito's F250 05 6.0 Harley Davidson TOYO RIZE RBP SCT MBRP S&

08_xl_odometer

river_pic

Bullet proof diesel oil cooler kit install

'07 5.9 Cummins

2011-08-05_17-38-25_228

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

rusty1161

Total: 454 (members: 1, guests: 453)

Top