Reply to thread

Message: [QUOTE="Tiha, post: 1563476, member: 33189"] Well low pressure is 62 psi per maual gage. Still won't start. Rail psi not coming up. Pulled intake again. Pulled flow control valve. Still clean. Pump full of fuel. Found this. "quick tip here. The typical failure with cp4 pump is a bad valve seat on the Intake non-return valve (suction valves). We have found that when an injector line is cracked open, and the key turned on to operate the lift pump a good cp4 the fuel will ooze out. In the case of failed suction valves the fuel will poor out and travels about 1.5 to 2 inches up." I tried it and my fuel definitely shoots into the air a few inches. According to that my cp4 went bad. Sitting in my garage. Nice. Can anyone confirm? I am not even sure what to check next. I unplugged the pressure sensor so it showed 30k rail pressure. Still no start. [/QUOTE]

Verification

Random media

1308247057569

3E43Ga3F85G75Ff5Jed254d2e574e6b221a7f

My truck

after plasti dip spray

rick_dyno

Boat1

no_limit_6_0_kit

IMAG0209

2011-04-12_17-36-05_398

IMG_20130430_194403_539

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

rusty1161

Total: 695 (members: 1, guests: 694)

Top