Reply to thread

Message: [QUOTE="NitroJoe, post: 1568099, member: 39600"] ok, weird issue. I have been driving the Ex in and out of the work area for weeks. I reassembled everything (interior, dash, etc.) and got the family together for the inaugural around-the-neighborhood test. I loaded everyone up, and guess what? Crank no Start. There's nothing like looking like an idiot in front of the family. Once I could see a color other than red, I started to reverse the reassembly and found this: When the 2 small screws are used to attach the plastic PCM holder to the metal frame I get a No PCM detected from ForScan. Remove the screws and the truck starts up. The best I can gather the torque is messing with the hydra (because the main harness is in a grommet that flexes). Should I have cut a hole in the plastic PCM frame? I just slid (pressed) it over top of the PCM and chip. Thoughts, Joe? [/QUOTE]

Verification

Random media

before plasti dip spray

My 6.4s

Quacker_State

amps

20180408_150031

bryanstruck

DSCF3330

Stock TDE1 Timing

20160924_133912

Misc_044

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Today at 8:52 AM
7.3 Tech
A few turbo questions and a rant
- Latest: Tiha
- Today at 8:22 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: RascalMafia
- Yesterday at 2:52 PM
Southeast US
Stage 2 LPFS for a 6.0 Powerstroke
- Latest: powerlifter405
- Friday at 11:58 PM
Engine and Drivetrain
0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Friday at 2:44 PM
Aftermarket Performance

Members online

Powerstroke Cowboy

Total: 1,235 (members: 2, guests: 1,233)

Top