Reply to thread

Message: [QUOTE="91turbogsx, post: 1139607, member: 14"] I just recently built a trans, all new clutches, gaskets, seals, etc. Along with a DPC converter. Got it running just yesterday and it moves forward and reverse a couple feet and then just stops. Seems to work much better right after I just start it but after going back and forth a few times it's worse. It'll move slightly with throttle applied but something isn't right. Anyone have any ideas? Batteries were disconnected for a few hours before start up. It's full of fluid. I pressure tested it and it has pressure although it fluctuates alot in gear up and down about 30 psi +/-. No strange delays from forward to reverse. It just moves a few feet and then stops. No codes either. No loss of pressure when it stops. Could a certain solenoid cause this issue? I thoroughly cleaned the solenoid body inside and out but reused the solenoids. Any help is appreciated. [/QUOTE]

Verification

Random media

Capone

d60_3_

IMG_20140824_203833_842

Turkey_Run_036

Da Pumpkin Truk Facebook Gem

wopshirt

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Today at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

DEEZUZ

Total: 625 (members: 1, guests: 624)

Top