Reply to thread

Message: [QUOTE="windrunner408, post: 774331, member: 1868"] This is merely a matter of opinion. IMO, flow sheets from the injector builder of their own injectors is worth about as much as the paper the flow values are printed on. If you're not going to trust the injector builder to build your injectors correctly the first time, then the only way to verify that they were done correctly is to have them flowed by a third party. Either way if the injectors are off it'll show up in some form or fashion (flow, vehicle performance, etc.). I think it's hilarious with all of this nut swinging of "certain mfg's injectors" because they flow test their own injectors. For the record, I'm not arguing that injectors shouldn't be flow tested. I just think they should be flow tested by an independent party and even then those results could get skewed. [/QUOTE]

Verification

Random media

dd_maximizer_hardware

20140904_154908-1

Gemma_Lee_Farrell

rear_axle_11_

IMG_20110628_153635

IMAG1090

1511MG-368

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

DonaldGaple

Total: 1,384 (members: 1, guests: 1,383)

Top