Reply to thread

Message: [QUOTE="Ad8 PRODIGY, post: 699361, member: 3842"] Seems like we fixed the injector issue. To me so far I haven't noticed it... swapped the engine harness over. Boy oh boy was that a bad hack job on it. Hacked it up and added his EBPV exhaust brake setup. Old harness out. Scary that it ran as well as it did all the way home [IMG]http://img.tapatalk.com/d/13/06/10/epuhe2a9.jpg[/IMG] Also found out the idler pullet was SHOT. luckily we saw it and had a spare to swap it out with. Originally it was a short arm pulley but we replaced it with the long arm we had on hand. Works fine, just had to loosen it more. We didn't get to paint it either. Took most of the day with the pulley and harness and fixing up all the other little crap. Might paint the bed this week after work, gotta leave the frame and wheels until next weekend. Gonna pull the bed and finish the middle under side and paint the frame while its off. Gonna wait until then with the wheels also because our floor jack chit the bed. New pic of it today before I left. Same thing, just a little cleaner and clearer picture. [IMG]http://img.tapatalk.com/d/13/06/10/e5aqazuq.jpg[/IMG] [/QUOTE]

Verification

Random media

2011-07-15_18-45-26_42

IMG_20111001_135206

truck28

154478_484105878920_736593920_5561927_7174616_n

Buster the wayward Boxer :)

Duramax hauling grain truck

befor an after

intake elbow upgrade

0208151604

befor an after

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Yesterday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Yesterday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Yesterday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Yesterday at 1:00 AM
7.3 Tech & FAQ
Truck slipping into 4th
- Latest: ju015dd
- Wednesday at 10:39 PM
6.7 Tech

Members online

No members online now.

Total: 683 (members: 0, guests: 683)

Top