Midwest ss intake help

[higherlife]

Alright guys, I'm pretty stumped on how this kit is put on. If anyone has a guide or install I would much appreciate. The parts just don't make sense to me and where they go. Am I missing something?
Thanks

 

[Powerstroked162]

PM'd you my number. Give me a call. I'm around the phone at the moment and can help walk you through install

 

[maxxedout]

Just curious, does this kit eliminate ALL the plastic pieces?

Also, does it accommodate the IAT/temp sensor, or is that removed too?

 

[Morgan@Midwest Diesel & Auto]

These should help.

You need to remove your lower intake.

The ready is all drop in. There is a piece of paper in there that tell you how to remove and re-use the factory turbo quick connect boot.


Sent from my iPhone using Tapatalk

 

[Morgan@Midwest Diesel & Auto]

Just curious, does this kit eliminate ALL the plastic pieces?

Also, does it accommodate the IAT/temp sensor, or is that removed too?

Iat is in the maf sensor. Map sensor provisions are there just like stock.


Sent from my iPhone using Tapatalk

 

[maxxedout]

I meant the CAC outlet temperature sensor. I can't see if there's a bung for it.

 

[Morgan@Midwest Diesel & Auto]

No there isn't. I want to add that, just haven't found a place able to machine it out of stainless. They can do aluminum, but not stainless.


Sent from my iPhone using Tapatalk

 

[higherlife]

Bare with me now but the lower intake is the piece that is has the square hole and a few other smaller round ones? It's connected to the turbo right?

 

[Powerstroked162]

Yes Sir. I sent you a reply in your PM with it broke down for ya.

 

[Morgan@Midwest Diesel & Auto]

You need to remove every air pipe connected to the turbo except for the exhaust side. That includes the lower cast aluminum intake, and the upper plastic intake. Take a closer look at the pictures I posted. The kit replaces all of the intake piping. Pm me if needed.


Sent from my iPhone using Tapatalk

 

[higherlife]

You need to remove every air pipe connected to the turbo except for the exhaust side. That includes the lower cast aluminum intake, and the upper plastic intake. Take a closer look at the pictures I posted. The kit replaces all of the intake piping. Pm me if needed.


Sent from my iPhone using Tapatalk

install went great, i sometimes over think things and make something simple more complicated than what it is.
What sensors do you have running to the y pipe, one looks blocked off but the other looks like you have something running to it.

thanks

 

[higherlife]

also what did you do with the black flex house that was attached to original lower intake?

 

[powerstroke22]

also what did you do with the black flex house that was attached to original lower intake?

That is the ccv hose back into the intake.

You can just zip tie it down away from the top of the motor or get Steve to hook you up with his ccv kit and lose the entire black box on the right side of the motor.