Reply to thread

Message: [QUOTE="Matt_P, post: 479666, member: 277"] Thanks to the snow we had a delay this morning so I only got to work about two hours today, but I got started on the honing. Its definitely going .040 over. [ATTACH=full]97252[/ATTACH] The cylinder that we had to press the piston out of after going .008 over [ATTACH=full]97253[/ATTACH] After going .020 over [ATTACH=full]97254[/ATTACH] Cylinder 1 that had the other rusted piston in it after going .020 [ATTACH=full]97255[/ATTACH] This one was unexpected. Nice big ridge in cylinder 3 still there after .020 over. Cylinder 6 cleaned up fine with .020 and still need to do 2 and 4 [ATTACH=full]97256[/ATTACH] [ATTACH=full]97257[/ATTACH] [/QUOTE]

Verification

Random media

phone_pics_048

rear_axle_13_

Fall_Pic

RACK_1_

triples

67ic2

IMG_20130401_210424_710

1385515194771

Loaded

eleanor_part_two_12_

Latest posts

I
A few turbo questions and a rant
- Latest: INFRNL
- Today at 4:05 PM
7.3 Aftermarket
N
Indiana
- Latest: Novapower62
- Today at 10:58 AM
6.4 Tech
N
Do not recommend Choate Engineering
- Latest: Novapower62
- Today at 10:56 AM
Newly Enlisted
Indiana
- Latest: glog
- Today at 10:40 AM
6.4 Tech
J
Tuning the 7.3 in current times
- Latest: JoeDiesle
- Today at 10:05 AM
7.3 Aftermarket

Members online

Raider4044

Total: 1,233 (members: 1, guests: 1,232)

Top