Reply to thread

Message: [QUOTE="Matt_P, post: 853563, member: 277"] Spent today putting new axle shaft u joints in and assembling the front axle some more and working on making everything for the rear disc conversion. Mock up is pretty much completely done, still needs some tweaking though. Started by putting the hubs on the lathe and turning down the small lip on the back side of the hub so that the rotor would sit down flush with the stud holes [ATTACH=full]122389[/ATTACH] [ATTACH=full]122390[/ATTACH] Went with front rotors off an 86 K20 as well as front single 2 15/16 piston calipers from the same truck [ATTACH=full]122391[/ATTACH] Cutting out he caliper brackets and spacers [ATTACH=full]122392[/ATTACH] Mock up bracket [ATTACH=full]122393[/ATTACH] [ATTACH=full]122394[/ATTACH] [/QUOTE]

Verification

Random media

rear_axle_8_

twisted_girth

20160402_132533

IMG_20120223_155925

2011-11-09_18-17-31_624

IMG_20111108_121916

32c11c85

Polished

Mishimoto 6.4 radiator

17_3

Step_8-2

Latest posts

I
7.3 LPOP Problem
- Latest: INFRNL
- Yesterday at 4:04 PM
7.3 Tech
Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Friday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Friday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Friday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Friday at 1:00 AM
7.3 Tech & FAQ

Members online

No members online now.

Total: 1,194 (members: 0, guests: 1,194)

Top