Reply to thread

Message: [QUOTE="zilla68, post: 1189666, member: 1410"] so upon doing my bronco tank install, I realized that the draw tube that I installed wasn't bent at the right angle (installed in the sending unit) and that I was going to be losing about a 1/4 tank of fuel, tried bending it also and just didn't like what I had. so I contacted dennis at strictly diesel to see if his fass sump set up might work. he went back grabbed all the parts and figured the draw straw of his efuel set up was the same size as the fass pick up tube. I didn't want to run a sump due to the hose hanging out the bottom and risk snagging it on something and causing me issues, so I went this set up. had the bronco tank cut and welded with a steel plate to mount the sump to since the stock spot wasn't big enough to mount the sump to. I will see if the spare will fit in there also, and I will need to trim out the center of the skid plate that holds the tank in, but so far everything seems to be lining up right. trial fitting shows no interference with the sender and the white tube that comes with the fass set up. [/QUOTE]

Verification

Random media

Another View

bed bolt

jackburton

Kazakhstan

Relay plug

PART_1421341333831_20150115_105859

IMG_20120106_133328

FB_IMG_1524919656191

Latest posts

0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Today at 2:44 PM
Aftermarket Performance
A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Wednesday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US

Members online

Total: 1,174 (members: 2, guests: 1,172)

Top