Reply to thread

Message: [QUOTE="Dzchey21, post: 1304914, member: 63"] so since its 4wd you wont be able to get it that low without some major modifications to the frame. basically you would need to C-notch the front frame to get it that low. Here is about as low as you can go with a 4wd, I had this set up for some years and it rode ok, only issue I had was large bumps would bottom the axle out on the frame. There are probably some good bump stop solutions to resolve this. Cut front coils (about 1" room between the axle and the stock bump stop bracket with no bump stop) No rear block, and the main leaf removed from the spring pack. [ATTACH=full]158871[/ATTACH] [ATTACH=full]158872[/ATTACH] [/QUOTE]

Verification

Random media

photo-11

Capone

front view2

2008 Ford F-250

IMG_20111001_135206

side_view_truck

03 7.3 ZF6

photo-10

tapatalk_1318100154816

Latest posts

Indiana
- Latest: Powerstroke Cowboy
- 30 minutes ago
6.4 Tech
Y
Performance shops
- Latest: Yojih123
- Today at 10:47 PM
7.3 Performance
I
A few turbo questions and a rant
- Latest: INFRNL
- Today at 4:05 PM
7.3 Aftermarket
N
Do not recommend Choate Engineering
- Latest: Novapower62
- Today at 10:56 AM
Newly Enlisted
Indiana
- Latest: glog
- Today at 10:40 AM
6.4 Tech

Members online

Lugger007

Total: 1,241 (members: 1, guests: 1,240)

Top