Reply to thread

Message: [QUOTE="gahm3r, post: 1566338, member: 24892"] I drove my F450 2500 miles (AK to OR) to pick up a new truck camper (about 4000 lbs). The way down was unloaded and didn't really notice any issues. On the way home loaded the converter clutch would slip from about 50-60 mph if the there was too much power going through it. This happened at about 20PSI of boost. I stopped it from happening by speeding up so the converter was spinning around 2050rpm and it seemed to reach stall speed and help out the clutch. I got home and ordered a new Precision Industries torque converter and now the truck stalls in Reverse and when come to a stop and the trans shifts down, i assume 1st gear. I am assuming a solenoid problem or leak somewhere in transmission is causing pressure to surge and be applied to the converter clutch. Line pressure d on my Auto Agent looks like it builds up and spikes to about 220 right before the converter locks and truck dies. Can anyone help me figure out what i should troubleshoot next? [/QUOTE]

Verification

Random media

Magneto_rear_v2

fender_off1

heads_on

step_12-2

step_12-1

truck_11

phone_2017_218

Boat1

2012-07-17_21-49-31_992

IMG_20140506_222559_903

photo_8_1

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Yesterday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Yesterday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Yesterday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Yesterday at 1:00 AM
7.3 Tech & FAQ
Truck slipping into 4th
- Latest: ju015dd
- Wednesday at 10:39 PM
6.7 Tech

Members online

No members online now.

Total: 500 (members: 0, guests: 500)

Top