Reply to thread

Message: [QUOTE="windrunner408, post: 498724, member: 1868"] Turbine spool is going to be based on how much energy is efficiently transfered from the exhaust gases to the turbine wheel. So while there are A LOT of factors that contribute to the energy possessed in the exhaust gases, I think that heat and straight up flow (lb/min) are going to be two most prominent factors. Of course there really isn't anyway to measure true flow so I guess drive pressure could be used. I would just be careful about that because if the exhaust has a horrible delivery system (i.e. stock up-pipes) then the drive pressure might not be a good indicator for that. Just some thoughts. [/QUOTE]

Random media

Da Pumpkin Truk Facebook Gem

after plasti dip spray

20140706_190146

13615140_1359443464083558_3787105765199931527_n

photo_7_3

Truck

2017IC

IMAG01631

Latest posts

0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Today at 2:44 PM
Aftermarket Performance
A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Wednesday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US

Members online

Powerstroke Cowboy

Total: 1,259 (members: 1, guests: 1,258)

Top