Reply to thread

Message: [QUOTE="m j, post: 933025, member: 9848"] I would have to look it up again but, dont you require some special tools to do a nozzle swap? bare minimum a spanner wrench and a fixture to hold the injector so add that type of expense to the cost I dont think a nozzle swap is a driveway type install (and I did my locker installations in my driveway at below freezing temps) there is info in these videos. [url]https://www.youtube.com/watch?v=NXRbY5d9KT0[/url] if you were going to do it I would look at doing a hybrid swap while you were in there sounds fun, post pics if you do it [/QUOTE]

Verification

Random media

Picture_065

E3C86D5E-47C5-49F5-8132-236D0B14FEDD

2001_Durango

psdragster

DSCN6165

s-l500_8_

2011-09-28_19-43-53_129

Dewalt

Hallers dyno 7-28-12

Turkey_Run_036

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

No members online now.

Total: 1,299 (members: 0, guests: 1,299)

Top