Reply to thread

Message: [QUOTE="Hotrodtractor, post: 416884, member: 25"] I helped install a back half on an S10 once. Measure about a dozen times, cut, pray, measure a dozen more times, weld, measure a dozen more times, race. Seriously - find a common datum that is going to stay on the truck - find the center-line - weld in some reinforcing bracing - make your cuts - align the new frame rails with all the previous measurements - tack it in, measure everything, weld it in, measure everything. Link setup is a whole lot of info that would take a while to compile and explain in a post. FWIW - I'm in the rough planning phases right now for doing one - probably be next spring/summer by the time I am to that point. [/QUOTE]

Verification

Random media

eleanor_part_two_76_

845DCA94-03AD-49A1-A9DD-BB7770B1BD63

Slaughtered

2012-04-06_12-35-14_805

Photo0126_1_

dads_truck_044

Built_Up_Motor_2

20170502_2125011

2006 F350 CCLB PSD

20170122_111247

Latest posts

D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- Yesterday at 5:23 PM
6.4 Tech & FAQ
S
F-350 Dually tire size
- Latest: Smokin 6.0
- Yesterday at 5:14 PM
6.7 Tech & FAQ
Won’t start issues
- Latest: psduser1
- Sunday at 8:30 PM
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- Sunday at 8:27 PM
7.3 Tech & FAQ
F-250 & F-350 gear ratio question ?
- Latest: Mark Kovalsky
- Sunday at 6:57 PM
6.7 Tech & FAQ

Members online

No members online now.

Total: 730 (members: 0, guests: 730)

Top