Reply to thread

Message: [QUOTE="TooManyToys, post: 1529900, member: 30841"] The FelPro's are a thicker gasket overall (0.010") and use a different approach than the factory design. When I talked to them they stated the gasket, like all other gasket manufacturers, were not designed with any thought towards o-rings and had no opinion if they were compatible. There's one machine shop that states not to use, maybe UFC. My point about the high heat question was it was the only time I've seen an example of the gasket blowing at that location, and if you didn't experience high heat then someone should look closely at the deck surface at that location, they may have wallowed it out during prep. I would have gone legal by the third time. [/QUOTE]

Verification

Random media

new_badge

tearing her down

2012-04-24_18-45-52_6

99.5 7.3

IMAG0331

P1060067

Cold_Stack

2013-03-05_10-51-53_491

Center Console

The Truck

Latest posts

S
F-250 & F-350 gear ratio question ?
- Latest: Smokin 6.0
- 13 minutes ago
6.7 Tech & FAQ
D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- Thursday at 5:23 PM
6.4 Tech & FAQ
S
F-350 Dually tire size
- Latest: Smokin 6.0
- Thursday at 5:14 PM
6.7 Tech & FAQ
Won’t start issues
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- May 18, 2025
7.3 Tech & FAQ

Members online

Smokin 6.0

Total: 392 (members: 1, guests: 391)

Top