Reply to thread

Message: [QUOTE="imelmo, post: 1430101, member: 110"] So I pulled the cab on ZMBYKLR. I was in Mexico doing some racing and when I cranked it up to leave it was making a popping noise out the intake. Got the valve covers off and found two rockers broke on the same cylinder. I checked the pushrods and they are straight. I'm going to do a compression check tomorrow and watch the assembly as it turns over to see if anything looks funny. My concern is it appears there is a piece of the shorter rocker missing (see pics) and possibly a very small bit of the long rocker as well. On the longer one it doesn't appear to be much, just the one end doesn't quite match up. I did find the ball bearings. The short rocker is missing about a 1/4" piece out of the bottom though. I looked and do not see it anywhere. Is this something I need to be concerned with? I see the holes at the bottom of the head and that's the only place I can think of that it could've gone. I'm guessing the holes are where the oil drains back down. Should I try fishing down the holes with a magnet or something? [ATTACH=full]169202[/ATTACH] [ATTACH=full]169203[/ATTACH] [ATTACH=full]169204[/ATTACH] . [/QUOTE]

Verification

Random media

2011-07-23_22_07_42

B440560A-CFF0-41C1-9C01-0F60F3EDDDFC

DSCN8405

2015-08-03_21_12_50

00g0g_U12u7FLHa1_600x450

Magneto_front

Our 2.6 Sled Truck

2nd_gear_converter_lock

after leveling kit

P1060067

Latest posts

D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- Thursday at 5:23 PM
6.4 Tech & FAQ
S
F-350 Dually tire size
- Latest: Smokin 6.0
- Thursday at 5:14 PM
6.7 Tech & FAQ
Won’t start issues
- Latest: psduser1
- Sunday at 8:30 PM
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- Sunday at 8:27 PM
7.3 Tech & FAQ
F-250 & F-350 gear ratio question ?
- Latest: Mark Kovalsky
- Sunday at 6:57 PM
6.7 Tech & FAQ

Members online

No members online now.

Total: 678 (members: 0, guests: 678)

Top