Reply to thread

Message: [QUOTE="tbsimmons, post: 110000, member: 2026"] Looks to be too much shim to me. Been a couple of years since I have done gears but I seem to remember it being backwards. To much shim would put it on the outside of the ring gear. It could also be they didnt crush the sleeve all the way. I have a set of bearings and a crush sleeve that I use to get all the shims right. THe bearings slide on and off. Once I get the shims right then I use a press. Gears should not whine. If they do they were not set up right. Most problems can go back to the pinion, either depth or not being tight. [/QUOTE]

Verification

Random media

step_8-1

red_trailer

DSCF1079

Engine3

2013-01-06_17-11-25_142

my stufff

1385598771752

97 psd

CF365ECC-4E81-4D8A-BED8-B526B9B722D6

2012-07-17_21-49-00_441

IMG-20111127-00002

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Yesterday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Yesterday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Yesterday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Yesterday at 1:00 AM
7.3 Tech & FAQ
Truck slipping into 4th
- Latest: ju015dd
- Wednesday at 10:39 PM
6.7 Tech

Members online

No members online now.

Total: 586 (members: 0, guests: 586)

Top