S468 install Question

Obsledpuller · Jan 6, 2014

Hey guys I'm putting a S468 turbo kit on from irate and was wondering it looks like I need to switch the valve covers. Is so I have an extra set can I just use passenger side valve covers on both sides? Or is that going to cause a problem?

Dmstrucks02 · Jan 6, 2014

Where's the cranck case vent going to go?

Sent from my SAMSUNG-SGH-I537 using Tapatalk

Nodge · Jan 6, 2014

I got mine installed with the valve covers on the correct side. I already had the doghouse flipped around and a vent hose ran down under the cab. It's a tight fit, but it will go on.

Obsledpuller · Jan 6, 2014

Dmstrucks02 said:
Where's the cranck case vent going to go?

Sent from my SAMSUNG-SGH-I537 using Tapatalk

That's why I was asking was wondering if I can eliminate it? Or would the pressure be too much?

Dmstrucks02 · Jan 6, 2014

No you need it, the intake should clear

Sent from my SAMSUNG-SGH-I537 using Tapatalk

Obsledpuller · Jan 6, 2014

Ok thanks

David N · Jan 6, 2014

Just swap them, and put the driver's side on the passenger side, and vice versa.

Obsledpuller · Jan 6, 2014

It wouldn't fit so I put two passenger side covers on and put a k and n crankcase breather in the place of the actual passenger side oil cap.

m j · Jan 6, 2014

I got it to fit
same way Nodge did it.

Obsledpuller · Jan 7, 2014

M j what size fitting did you use to plug the one hole and what size is the other one you used on the intake y to the map sensor?

m j · Jan 7, 2014

both came from irate. the big one looks to be 3/8npt
I can verify those for you this weekend, or sooner if I get a day off

I didnt even tighten those for the first test run, the plug ended up in the valley