Redpower
Member
I have been looking high and low for a set of seat tracks for my 95 RC. The plan is to put the 40/20/40 seat from a crew cab in, but the track on my base is bad. Anyone got some ideas?
Seat Track
- Thread starter Redpower
- Start date
zilla68
Active member
check craigslist for a parted truck, are they the same for the 40/20/40 and the other seat?
Redpower
Member
No, they are not the same mounts. My current seat is the bench seat and the one I want to put in is the seats with the jump seat in the center.
Bugman
Active member
Go to the junk yard. Remember that it doesn't have to be from a diesel
97powerstroke
New member
Maybe something out of a bronco, explorer or newer truck would work. I couldn't see why they would've made different seat tracks for everything. I would think they made a couple different ones that worked in everything. I might be wrong but its worth looking into.
Redpower
Member
I think all you guys might be right. Looking at the mounts on my bench seat and I think its the same track, just different mounts below. I think if I grind out the rivets, cut the old mounts off, and drill some bigger holes they might work. I was hoping to avoid that much work.......
JD3020
Active member
The tracks are the same between the buckets and 40/20/40 i believe, but the regular and crew cabs use a pan of some sorts to bolt them to the floor, whereas Broncos and extended cabs bolt directly to the floor.
97powerstroke
New member
Yea all the brackets are different but the tracks themselves should be the same I would think.
