Reply to thread

Message: [QUOTE="Brad.S.19, post: 1108220, member: 12605"] Got the x-codes, wheels and tires on, now I need a carrier bearing and the current drive angle is about 6 degrees. I am curious as to the better of the manufacturers of the bearing and holder hoop. As for shims were would a good starting pointing for a thinkness point be none are in atm. My shift points or the rpm I am running are not matching road speed @ 65 I am turning 1900 in od no problem. but when going the back roads back to school they are curvy hills mostly 40-55 I try to maintain around that I try to gain speed into them with light throttle then it starts slowing down about 5-10 +/- mph drops from 1800ish rpm to 1400< drops down revs to 2000 thought I had a stuck caliper but just water splashing onto them making steam. The new set up is 16x10 4.5 bs w/ -25mm with 305/70r16 toyo open country m/t basically a 33 the stock size was a 265/75r16 for my truck just really annoying. [/QUOTE]

Verification

Random media

20120712182800

12345

1st_gear_converter_lock

O&G's 2011 F250 Journey

trucks1

625521_10150959063566300_1077575649_n

169815_1660981239184_1076760051_1781960_6725912_o

New Headlights 6

2011-07-19_18-00-01_887

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Yesterday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Yesterday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Yesterday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Yesterday at 1:00 AM
7.3 Tech & FAQ
Truck slipping into 4th
- Latest: ju015dd
- Wednesday at 10:39 PM
6.7 Tech

Members online

Lugger007

Total: 662 (members: 1, guests: 661)

Top