Reply to thread

Message: [QUOTE="TARM, post: 304029, member: 578"] I in no way said it would not work. There is a difference between something not working at all and something causes a decrease in performance compared to another setup. Point being that putting it on the turbine housing is going to have more negative effects than putting it on the collector or somewhere after the manifold and before the turbine housing. It certainly does work as I had already know people that have done this. It is done in a number of gasser setups with even turbine housings casted with the WG mount integrated into it. They are for those with limited room. But its a trade off and not ideal. I believe a few were tested back to back but it was small cu inch gas engines. Maybe the effects are lessened on big cubic inch high boost diesel engines as after all we are bleeding off far less than the lower boost gas engines run. As I said before from everything I have read and seen it would not be my first choice given the other choices available in this setup.. [/QUOTE]

Verification

Random media

919123_367663446688562_990954678_o

20180513_171405_Burst01

33A15B20-14B1-4313-BC10-E62F79D58FED

2013-03-21_17-48-48_681

97 F350 4x4

top-1

he451ve turbine

Center Console

dualIPR

2013-03-21_16-56-09_370

Scuff pad used. Not

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

Total: 1,305 (members: 2, guests: 1,303)

Top