Reply to thread

Message: [QUOTE="Charles, post: 292724, member: 103"] Nope. It'll stop it dead in it's tracks if it's programmed to pull MFD to nothing shortly past your full cut point. I've broken two converter hubs, one OD planet, one input shaft, one driveshaft u-joint and one differential carrier. My engine has never over-revved the 3850rpm limit. I'm simply suggesting that a tiny bit of effort toward making the limiter actually limit the engine might be a good investment considering that broken driveline isn't necessarily the exception, but more the rule at that power level and beyond. Just seemed like you needed to know that YES, the limiter WILL stop the engine RIGHT NOW, no matter what you have going on. You stop the injectors and I ASSURE YOU, that the engine will stop accelerating immediately, barring the existence of any other injected fuel source like propane. Just know that. If your program overruns the limiter, it's not because the PCM can't stop the engine. It's because it's not being told to. It's not a 1970's gasser with solid lifters. It's a fully electronic engine. [/QUOTE]

Verification

Random media

Chimay

Busted Driveshaft OversizeLoad

2011-07-06_22-25-01_636

2013-02-12_14-57-48_87

injector clearance

Busted Driveshaft OversizeLoad

exit_2_5

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 11:41 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Yesterday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Yesterday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

Total: 1,166 (members: 4, guests: 1,162)

Top