Reply to thread

Message: [QUOTE="ghohouston, post: 749206, member: 9421"] Well hell no a shop isnt going to do studs one at a time. But if its a guy in his garage doing his own work, it wont hurt to do the one at a time method, if it works, it works, if it doesnt, then he is only out a few hours on his own time. That doesnt reflect poorly on my knowlesge one bit. And the **** theyre "good or bad". You can pop a freshly installed head gasket, if it hasnt had enough heat cycles on it to properly "seat" or "seal" where as with a seasoned one, theyre not gonna pop with the one at a time method. Go ask any of the big names on here, and they will tell you the same. And I went and did some research last night, and there were infact quite a few very well known guys on here that studded one at a time with great luck [/QUOTE]

Random media

Jolene_posted_on_um

Headlights

20160402_132533

1511MG-368

old trucks

Glow Plugs

185416_1696700276900_1819675359_1126088_3953980_n

20150130_140704

old trucks

under the hood

Latest posts

0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Today at 2:44 PM
Aftermarket Performance
A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Wednesday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US

Members online

Total: 1,142 (members: 4, guests: 1,138)

Top