Reply to thread

Message: [QUOTE="kleake, post: 1400026, member: 25987"] Valve stem height is supposed to be set from spring seat surface on the casting, to the tip of the valve stem. If it was set after the seal was installed, the stem height would be the thickness of that seal too high. If the stem is too tall, the lifter can't take up that much slack and bottoms out, holding the valve open. Per factory spec, the stem height should be 2.300-2.320. Say the seal is .250 thick (guessing) then the stem height would be around 2.550. I hope that makes sense, I'm pretty confused myself on this mess. Sent from my SM-G935R4 using Tapatalk [/QUOTE]

Verification

Random media

Punisher_s_1st_Photo_shoot_009

garrett

baja_rack_PIC_

102_0243

DSCF1079

eleanor_wiring_4_

2013-03-05_10-51-53_491

srt3

eleanor_part_two_31_

Latest posts

02 F250 7.3 Will crank, WTS stays on, no start, no OBD
- Latest: Sterling6.7
- Sunday at 8:57 PM
7.3 Tech
P0087
- Latest: DEEZUZ
- Sunday at 11:49 AM
6.4 Tech & FAQ
2015-2019 6.7 HPFP New In Box
- Latest: lincolnlocker
- Jun 1, 2026
Engine and Drivetrain
First 6.0L (56k warning)
- Latest: adrianspeeder
- May 26, 2026
6.0 Tech
Extra external motor oil cooler?
- Latest: justinlogue5_0
- May 26, 2026
7.3 Tech

Members online

No members online now.

Total: 4,928 (members: 0, guests: 4,928)

Top