Reply to thread

Message: [QUOTE="yavorssj, post: 793178, member: 7819"] 2000 Excursion, 7.3, 4x4 Here is the short story ---> I replaced all four calipers with the best NAPA had. New rear brake lines (not the center one). New green Hawk pads all the way around. Frozen Rotors up front with a set of Brembos in the back. New master cylinder. I bled the system... Now the brakes are locking up. Pressure is not relieving off any of the calipers. To confirm this, I jacked up the front and rear, and the wheels will NOT turn. In retrospect, I realize I made a BIG mistake... I did not bench bleed the new master cylinder. :fustrate: Now I have this problem and am not sure how to fix it. The pedal stays rock hard for about ten minutes, or until I bleed pressure off the system at one of the calipers. What do I need to do so I can fix my "temporary moment of stupid..."? Thanks :shrug: [/QUOTE]

Verification

Random media

dodgefail

2006 F250 6.0 PSD Lariat FX4

F250 King Ranch

Betsy_on_DYNO

IMAG0084

!sicpsd

High Pressure Oil Leak Problem

2016 F250!

Latest posts

A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 6:06 PM
7.3 Aftermarket
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Wednesday at 9:03 AM
7.3 Aftermarket
Georgia Roll Call
- Latest: ju015dd
- Tuesday at 7:03 AM
Southeast US
Ford 7.3 Passenger Bank Dead
- Latest: Powerstroke Cowboy
- Monday at 8:20 PM
7.3 Tech

Members online

No members online now.

Total: 1,036 (members: 0, guests: 1,036)

Top