Reply to thread

Message: [QUOTE="dsberman94, post: 1194522, member: 12667"] Not trying to make it a recording studio, just needed to quiet down the vibrations, which is what this did. Very well. Quieted down the exhaust very well. I doubled up on the front for a couple of reasons also. One being greater vibration dampening. Also I ended up pulling the factory heat pads that were stuck there so I did it for heat resistance as well. Completely covering the floor and eventually doing the ceiling and middle and rear pillars should give it some better insulation also to go along with the ting. Hopefully it's good insulation to keep the truck warmer and cooler for longer when it's not running also. But I got the front driver's side caliper and rotor replaced today as well as some new pads. Hopefully she will be good to go for a while. Many hours of love for it over the past two days. [/QUOTE]

Verification

Random media

2012-03-28_22-54-33_587

Punisher_s_1st_Photo_shoot_005

IMAG0362

IMG_20170714_182636

IMAG0206-1

White truck

zz_fab_manifold

Workstock, when not hooked to sled its hooked to trailers

IMAG0693

20140221_181947

Latest posts

Ford 7.3 Passenger Bank Dead
- Latest: 6.0 Tech
- Yesterday at 7:22 PM
7.3 Tech
J
6.4 spartan
- Latest: jmathews90
- Yesterday at 6:16 PM
6.4 Performance
Show & Go/Going to Try this Out combo Build
- Latest: Powerstroke Cowboy
- Yesterday at 9:06 AM
6.4 Aftermarket
Y
Fuel sending unit and wheel studs
- Latest: Yojih123
- Yesterday at 1:00 AM
7.3 Tech & FAQ
Truck slipping into 4th
- Latest: ju015dd
- Wednesday at 10:39 PM
6.7 Tech

Members online

No members online now.

Total: 563 (members: 0, guests: 563)

Top