Reply to thread

Message: [QUOTE="STR8LINE, post: 458477, member: 2646"] I couldnt wait after bolting them on!! lol Seriously tho, I Cut the bottoms of the fenders behind the tire.. Not much you cant even tell it unless you bend over an look close I didnt mind as Iam building a custom truck but its personal preference.. Now, Alot of that is because I went with 12" wheels and part of it is because I went with 13.5 wide tires... and Unfortunately today I figured out that I Think I have a bent tracking bar, I dont know for Sure yet but unless a stock bar has a bend an curve in it at the bottom end, then Mine is bent! If it is bent I plan on ordering some stuff an building an adjustable bar! I think in theory if I go any taller it would need too be longer anyways? Rightnow I think the axle is sitting offset too the center of the truck a bit too the drivers side where the bar is bent and its shortened in length.. The Drivers side was the worst By Far at rubbing too!! [/QUOTE]

Verification

Random media

front_axle_swap

2012-10-13_21-33-46_53

2012-10-09_16-57-03_441

20160526_164045

2013-01-31_21-06-33_882

stickers

IMG_20140101_211653_686

IMG_20140101_211738_431

Cquartz finest on hood

20181202_092432

Latest posts

Georgia Roll Call
- Latest: RascalMafia
- Today at 2:52 PM
Southeast US
A few turbo questions and a rant
- Latest: ghohouston
- Yesterday at 8:00 PM
7.3 Aftermarket
Stage 2 LPFS for a 6.0 Powerstroke
- Latest: powerlifter405
- Friday at 11:58 PM
Engine and Drivetrain
0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Friday at 2:44 PM
Aftermarket Performance
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US

Members online

No members online now.

Total: 1,316 (members: 0, guests: 1,316)

Top