Latest activity
-
NNitroJoe replied to the thread Ford 7.3 Passenger Bank Dead.Yes. The 7.3 will run on one bank. It will drive, but not well. A common test to isolate issues is to unplug one UVCH at a time.
-
DEEZUZ replied to the thread Ford 7.3 Passenger Bank Dead.This thing actually runs/idles with only left bank firing? -
NNitroJoe replied to the thread Ford 7.3 Passenger Bank Dead.Thank you for the suggestion. I didn't see it under all the gook. Once I cleaned the area and hooked up a pressure gauge it showed 100...
-
crash86 replied to the thread Lighting an old flame.Its a press fit.. I’ve taken them off before and never had any issues. To me it’s the only way to verify correct timing without the... -
DEEZUZ replied to the thread Ford 7.3 Passenger Bank Dead.Oh it's buried deep down in there.. I was able to get mine out without taking the accessories off. That was when I installed my Riffraff...
-
NNitroJoe replied to the thread Ford 7.3 Passenger Bank Dead.Yes on the line behind the pass head next to turbo, I removed the check valve and gutted it. Then blew out the line back towards fuel...
-
DEEZUZ replied to the thread Ford 7.3 Passenger Bank Dead.You removed/cleaned the filter screen on the cylinder head? You can remove the opposite end casting plug to make sure fuel is flowing...
-
NStory behind truck – I bought it as a crank no start and got it to this point. IDM was fried, injectors blown out. 2000 Ford Excursion...
-
Well the heads finally showed up this week. ~8 months from the day I ordered them so I hope they are worth the wait lol. Made a lot of... -
Derkperk replied to the thread Lighting an old flame.Nice work, looks great! Sent from my iPhone using Tapatalk -
DEEZUZ replied to the thread Lighting an old flame.What procedure did you use to keep the rear crank balancer center and true?
-
crash86 replied to the thread Lighting an old flame.Well the heads finally showed up this week. ~8 months from the day I ordered them so I hope they are worth the wait lol. Made a lot of...
-
-
DEEZUZ replied to the thread 2011 6.7 Issues to be concerned about. Is this a good deal??.What I've had is that the gasket is flat even or recessed into the groove. I actually resealed one and it came back a month later. The...
-
6.0 Tech replied to the thread 2011 6.7 Issues to be concerned about. Is this a good deal??.I didn’t see as many with 11–12 trucks due to them actually having a gasket. Granted the common issues seem to vary depending on where... -
DEEZUZ replied to the thread 2011 6.7 Issues to be concerned about. Is this a good deal??.Upper oil pan leaks
