Recent content by dave186

It's more of a click than a hum. It doesn't do it unless it has a load. Everything is smooth when i jack it up and spin by hand. Friend of mine has a spare t case so I'm going to try that. Sent from my iPhone using Tapatalk

Hey guys, havent been around for a while. I had to use 4x4 in my truck today for the first time since last year. I locked the hubs and drove around for quite a while before actually engaging the transfer case. When I did I eventually noticed a slight noise, its kind of a clicking or buzzing...

This thing looks pretty cool, thinking I might have to have one and Ive already got a DP chip. My question is, this plugs into the OBDII port right? I have a 95 model and Im a bit leery if it will work. Ive had trouble getting certain scan tools to work on it. any insight on this?

arent they just oversize for when the pump housing wears?

Im using alto koleene steels if that helps you, but im also using alto frictions.

Here is a good selection of most of the parts out there. I believe its been posted already. If your looking for a specific "recipe" thats a little harder. http://www.transmissioncenter.net/e4od.htm all you will need to make that 4x4 trans 2wd is an output shaft and the tail housing. easy to do...

the low/reverse hub from an E4OD is cast instead of stamped like the 4R100. you can use the one from the E4 but will need clutch disks and a new reverse planet. big issue there is finding a 6 pinion planet to fit the cast hub. Seem to be backordered everywhere. I have one in mine and had to pay...

I may have the small versions of those pics saved as well. I will dig thru my files.

I have built a couple of trans for myself and my buddies truck. I have a bunch of files I gathered in my researching stage. I could send them to someone if they wanted, I dont remember where I got all the stuff. At one point there was a real good write up I think by racerx but my bookmark for it...

Bump. Somebody must want this thing? Open to offers, maybe trades.

I decided to get a pump from Ford so here is a deal if someone wants it. Brand new still sealed in the bag NAPA water pump. Part number is 45007. Uses the short T stat and has the lower inlet cast as 1 piece. $100 shipped to your door. I also have a 4 month old motorcraft T stat I will throw in...

Those specs are for new components. A used set of gears and bearings are going to have more backlash, and no preload.

I was watching that thread but havent been over there much. I was just going to get the sky kit but thats not much more money, looks like its worth it.

Nice write up. what does that PMF kit cost?

Want to take a QSSB on trade?