Recent content by Fabbed5.0

What else would cause excessive vibration at idle? The crank dampener is in one piece and still looks new.

Hi all, I am getting an ever more noticeable vibration in my feet at idle and low throttle, looking around I do not se anything out f the ordinary and figured the motor mounts must be deteriorating. Has anyone replaced the motor mounts on their truck before?

Where can I order the vinyl wrap from.

So your saying that 00 and up leafs are all the same width? If so then these below should work? https://www.amazon.com/Adjustable-No-Squeak-Quality-Suspension-Advantage/dp/B00ENKH1AK

Correct the rear does not have any blocks from the factory. I can still align the front of the ibeams on 4500 springs. Does anyone know of a company that makes rear lowering leads? I tried looking for drop shackles for 11 up and came up with nothing.

Hey guys, Im sure this isn't a hot topic since most here would prefer to lift their truck but I want to lower mine. I use it primarily to tow and it stays on the pavement 95% of the time. I planned on using 4500lb front coils but after some research it looks like ill need some 2 in lower rear...

Jordan will this build be in the PMF booth?

Hey guys, My buddy is putting his 14 6.7 back to stock and I wanted to double check that his Minimax would work on my 2011 6.7 Is there any issues with putting his minimax on my truck? Also is the tune file the same? I was gonna swap his EGR D___te and exhaust also. Thanks for the help.

That's good to hear this feedback. So let me tell you guys what im trying to do. I have a 2011 6.7 2WD that I use as a daily and to haul my car too and from the racetrack. I am planning to keep it low and do a nice wheel and tire setup to help out the looks department. This truck will never...

Hey guys, Anyone on here run the 305/55/20 falken wildpeak at tires? Or in any other sizes? I have not heard much about them but I am looking to pull the trigger on some new tires and these caught my eye.

Why when I can keep them. Never know down the road when I might need them.

Thanks guys, ordered some factory bumpstops.

Looks like you guys are right, after searching around they do look like tembren stops. Couldn't imagine how anyone would like these overs bags the ride is not good loaded.

So I was putting some brake pads on my 11 6.7 and I got underneath it to visually check the truck out when I noticed how close the bumpstops are to the axle. This is a 2wd truck with no blocks in the rear (factory) I noticed when towed with a trailer it road kinda harsh in the rear. Whats...

I drive anywhere from 400-800 miles a week lol you can do the math.