Search results

Tittle pretty much says it all. I have a 1994 f250 7.3. I blew a head gasket so while I have everything apart I was wondering what I need to replace or upgrade while I have everything ripped apart. Any advice is appreciated. Sent from my iPhone using Tapatalk

Removing the turbo on my 94 to do a head gasket and I can not get the back drive side turbo pedistol bolt off. I have a 10mm swivel socket and all sorts of extensions on a little ratchet. Just wondering what the best way is to get to the bolt. Is the pic I have below the way to get to it, or am...

My 1994 f250 7.3 water pump started weeping so I replaced it and the thermostat and now it is over heating and pushing the coolant from the radiator into the resivor. And when I drive it'll stay at a decent temp but it's loosing coolant the whole time. And then when I get out to check the...

On my 94 f250 7.3 4x4 5 speed the brakes have always been soft and never really bothered me but I'm going to pick up a 30 ft gooseneck out of state here soon and would like my brakes to be perfect. So I replaced the master cylinder and bleed the brakes twice but if anything now they are worse...

I'm looking at buying a 2008 6.4 in really good shape for cheap because the guy says with a new battery he can get it to turn over but not start, by using the starter wire under the hood I believe? Owned plenty of 7.3's but I know nothing about these 6.4. Any insight would be great thanks...

I have a 1999 f250 7.3 and I just dropped the tank the clean the filters in the lift pump and it was a mess It looked like sand and just some bogger lookin stuff. I have cleaned it out before and it was never this bad so I'm stuck. What's the best way to handle this? Flush the tank, replacment...

I have a 1999 7.3 f250 automatic and I just put a new IDM in it and it was working fine and running great but now it is throwing a P1396 code and I can't clear it. And it seams to be running a little rough now.What sort of checklist can I run through to get this fixed and code cleared. Thanks

I've read all different things about this code but it seams like everyone has other codes as well as the p1211 wich is injector pressure above/below desired I believe it said. My service engine light has always gone on and off but now it's starting to run a little funky, like almost cut out or...

I have a leak coming from one of the tranny cooler lines and my question is, I know it's the rubber hose leaking, What size is the hose and is it just hose I need or does it need to have a special end on one side or the other, and how much hose do I need? From where I can tell it's leaking it's...