ncollins64
Well-known member
Does anyone know if a factory gooseneck hitch for a 13-16 would bolt on a 2006? I’m assuming the frames are different so could you drill the holes needed to mount it?
Thanks I’d appreciate that.If it helps, I did this on my 2010. Only need to drill 4 holes on the horizontal face of the top of the frame. All the side brackets bolt right up. I have a spare one in my storage trailer, I can take some measurements for you if you'd like.
Sent from my SM-G975U using Tapatalk
What measurements do you want? Width and bolt hole dimensions?Thanks I’d appreciate that.
Yes that should be good. I should be able to look at a hitch picture online and use your measurements to compare with. I don’t think this will be too hard to do as I’ve had my bed off recently so it’ll come off easy. Do you know if the gooseneck ball is in the same location as a b&w?What measurements do you want? Width and bolt hole dimensions?
Sent from my SM-G975U using Tapatalk
That I don't know. There's some room to move front to rear with the way the brackets are designed. Iirc, I set my hitch about one inch in front of the axle centerline, but it's been 9 years since I did this.Yes that should be good. I should be able to look at a hitch picture online and use your measurements to compare with. I don’t think this will be too hard to do as I’ve had my bed off recently so it’ll come off easy. Do you know if the gooseneck ball is in the same location as a b&w?