ImAti0n
Member
- Joined
- May 8, 2016
- Messages
- 225
- Reaction score
- 0
So I just got my EZ Lynk installed and pulled the SCT sensor out since I no longer need that. I pulled an EGT sensor from my deepeff and went to install it into the block off plate and it wouldn't fit. I immediately thought I had the wrong size plate because I had those plates sized for the 1/8" due to the SCT sensor I've been using.
So luckily I was able to find the adapter and get the sensor in, but now I'm having trouble figuring out which one to plug it into?!
Please see the pictures below so you see what I'm talking about. I'm at a loss.
Thanks!
Here's the adapter I was talking about to make the sensor fit.
Sensor all installed and tightened.
Notice the position of the prongs inside and the locking tabs on the outside.
This is the only sensor I can see it plugging into as the Orange one next to it is for the EGR.
I noticed this was unplugged is this what it could plug into?!
Thanks everyone
Sent from my iPhone using Tapatalk
So luckily I was able to find the adapter and get the sensor in, but now I'm having trouble figuring out which one to plug it into?!
Please see the pictures below so you see what I'm talking about. I'm at a loss.
Thanks!
Here's the adapter I was talking about to make the sensor fit.
Sensor all installed and tightened.
Notice the position of the prongs inside and the locking tabs on the outside.
This is the only sensor I can see it plugging into as the Orange one next to it is for the EGR.
I noticed this was unplugged is this what it could plug into?!
Thanks everyone
Sent from my iPhone using Tapatalk