Hp from s468

rollingcoal · Feb 11, 2013

Whats everyones opinion on how much HP a s468 74 .90 divided t4 turbo on a 6.0 with supporting mods will make??? Any guesses ?

06f250powerstroke · Feb 11, 2013

S366 will make around 800. so i would think the s468 should be able to make more

kyle43335 · Feb 11, 2013

rollingcoal said:
Whats everyones opinion on how much HP a s468 74 .90 divided t4 turbo on a 6.0 with supporting mods will make??? Any guesses ?

i will be trying out a s467.7 fmw .90 on my blue truck soon.

colinmitchell111 · Feb 11, 2013

06f250powerstroke said:
S366 will make around 800. so i would think the s468 should be able to make more

That seems high who did that?

Pizza pig · Feb 11, 2013

prolly on nitrous or with a 483 in front of it. As a single fuel only, its doesn't flow enough air on paper to make 800.

mattman347 · Feb 11, 2013

I would think the 468 would be good to 650-700. It should light ok, not sure how laggy it would be if at all.

rollingcoal · Feb 11, 2013

Was told it woodnt be to laggy with new up pipes and bellows . And the flow chart garret has on it shows it will support up to 700 hp maybe more. Its just no one is running this exact setup to be able to say it will make x amount of power. The build I start building was proven to make 575-600 and that was with a s366 with a billet wheel . Now iv jumped up to this s468 .

mattman347 · Feb 11, 2013

It is a real good turbo on my 7.3 and I have heard of people using it on a 6.0L I just don't know how it ran on the street.

rollingcoal · Feb 11, 2013

Well ill be sure to post how it does here in a few weeks

Pizza pig · Feb 11, 2013

The charger typically will only spool as fast as the turbine allows, this charger uses a 74/83 turbine, these turbines spool just find on the 6L. With a .90 housing, divided up pipes, the proper fuel and tuning it will light fairy well, and put down some serious power.

rollingcoal · Feb 11, 2013

Thats what im hoping for. Just wish I was closer the innovative diesel so eric cud dyno tune it .

Pizza pig · Feb 11, 2013

Youre not far from Texas, have Chris @ TSD tune it on their dyno or have Matt @ Gearhead street tune it. Well worth the drive.

rollingcoal · Feb 11, 2013

Is TSD in san antonio

Pizza pig · Feb 11, 2013

Yes, and they are a site sponsor here. They're great guys.

rollingcoal · Feb 11, 2013

Hmm sounds like I need to go visit my brother and swing by . Are you the same pizza pig from psn ?

Pizza pig · Feb 11, 2013

rollingcoal · Feb 11, 2013

Have u followed my 600hp thread on psn. ? With new turbo set up and mpd up pipes what kinda hp wood u think id push. I know with the s366 billet wheel wood make 575 to 600

Pizza pig · Feb 11, 2013

Just looked back and checked. Not sure really i'd venture to say it will be close to the 600 mark give or take. Its going to be fun on the street I will tell you that much.