Recent content by mandkole

Nice job, cool project.. hopefully the used trans gives you some love for a few more miles.

😆😆😆

Good deal 👍

Hmm.. It certainly doesn’t owe you anything but I think I’d be mic’ing the journals and rod ends closely. Assembly and component design have improved over the years. I’ve seen recent 1m mile big truck engines with amazing looking parts with typical care and OCIs.

Would be real surprised if anything but the gauge, sensor or wiring. Chased a couple of oil press gauges on the old obs. Had plenty of pressure w mech gauge.

😆 yep.. I was on the interstate when I literally saw the gauge go from good to not good. Had 6-8 miles before home.

Acts like coalescer but without a filter to separate the oil a little more.. interesting. I’ve been wanting to get the vent back into the intake.

Awesome, fun to see some new activity here again. Looking forward to the progress!

200/30s are really too small for the gt42. (Curious on your drive pressure with the .9 ) Even my 250/100s are a tad small (the 42 cleans them), appears it works best with 3/2s but I’ll change the charger before I add more fuel. My converter is based on a 6.0 and it stalls about 1800. It...

Nothing unusual about my BTS other than known mod stuff today. No billet, no locked coast clutch. My trans buddy who freshened it (4 yrs ago after the converter gave up) closely looked at it, and noted some minor things being done. Some frictions and a new converter, it gets the same 500 thru...

^^^^😆😆😆

I’ve had cold haze below 70 on casserlys for years now. They were freshened 8-9 yrs ago. My interest in chasing these little issues has been lost so I don’t eff with it unless something major is wrong.

Pretty sure he sold that truck awhile ago.

Yep, I just removed the original Mitsu a couple months ago. Should have done it a couple years ago.

:thumbup: for the new denso