Recent content by Willman940

I assume your trying to sell the axles whole? I'd be interested in the backing plate for the drivers side rear brakes.

I'm impressed that you reposted this for 11 pages......

What about going the other way, If I understood correctly, my truck (the 99.5) has the intake air heater where as an E99 harness has no place for it.

Since I'm a slow learner, IAH?

Just cause I'm a curious bastard what connector is it?

Do you have the split rear seat out of a extended cab 99-07?

Hello, for those of you who may remember, I have a late model 99 F250 SD 7.3/ZF6 that thanks to the previous owner has numerous wiring harness issues. There have been a few 'fixes' along the way but I'm fed up and would like to do it right. I have been told to get a compatible harness I need a...

Are those factory cab lights? Also for the glare problem, up here alot of GSO rigs come with flat black hoods so you don't get the glare in the low sun in the winter.

That's already done but the too is cut up.

Also could I buy the rear seat from you?

Are you swaping the wiring hardness too?

Does anyone know where I could find a blue print of floor plan of some type For a 1999.5 superduty with a zf6? My current one is a bit butchered from the previous owner and I am hoping to make a patch of some type so that the shift boot fits how it should instead of with self tapping screws...

Hold up where did you find that for 5K and what's wrong with it?

Pardon my ignorance but is electronics from 2x4 to 4x4 pretty simple? I only has because my truck is a nightmare electronics wise. Also since it's going up on the salt belt are you doing any rust prevention?

Well, my VIN and preduction date put it as a Late 99 last time I checked. But I can look again.